Level 1 sweep and inspection to the NFPA 211 annual standard - flue, crown, cap, and flashing checked and photographed
Chimney sweep logs do not sweep chimneys. They loosen some creosote - which then falls where a brush and vacuum still have to collect it.
Why Passaic Homeowners Choose DuraFlex Chimney Cleaning
Top Hat Chimney provides Duraflex service in Passaic, including independent chimney cleaning, inspection, and repair throughout Passaic, NJ, and we’ve worked on hundreds of these liners since the brand became common in local homes. We are not a DuraFlex-authorized contractor and we don’t pretend to be. What we are is a crew that has pulled enough DuraFlex liners apart, cleaned enough corrugations, and documented enough Passaic-specific failures to tell you exactly what’s going on inside your flue. Call (551) 368-8859 and Wendell Pike or one of his crew will give you a straight answer, usually with camera footage to back it up.
Passaic’s housing stock is the reason we see so much DuraFlex here. The older rowhouses along Gregory Avenue and throughout the mill neighborhoods were built for coal, then converted to oil, then gas. A lot of those flues were oversized for the fuel they ended up carrying, and DuraFlex liners became the go-to fix for resizing them. That means we clean and inspect DuraFlex liners in some of the oldest chimneys in Passaic, where the liner is doing more work than it was ever asked to do. We also handle Duraflex in Clifton for similar historic housing stock.
Why Trust Top Hat Chimney for Your DuraFlex Chimney Cleaning?
The sweep who shows up at your door needs to know the difference between a DuraFlex 316L liner and an AL 29-4C liner, because they behave differently under heat and they fail in different ways. Wendell Pike started Top Hat Chimney in 1999 and grew up learning the trade at Southwestern College in Chula Vista before years of apprenticing under sweeps who treated every flue like it mattered. That’s the approach his crew brings to every DuraFlex job in Passaic. We know which brush heads are safe for flexible corrugated liners and which ones will chew through the thin stainless. We know where DuraFlex connectors tend to corrode on older installs, and we know when a liner is worth saving and when you’re better off replacing a section. The camera footage and a plain-English verdict, every time, no exceptions.
We clean and inspect DuraFlex systems without the constraints of a manufacturer-authorized network. That matters because we’re not going to upsell you on a liner replacement when a proper cleaning and a new connector is all the flue actually needs. If it doesn’t need doing, we’ll tell you so. Every job gets the 90-Day Done Right Promise in writing, and the number you hear on the phone is the number on the invoice. With live phone answers 24/7, that’s how it works in Passaic and for Duraflex in Bloomfield.
Common DuraFlex Chimney Cleaning Problems We Fix in Passaic
Here’s what we actually find when we open up a DuraFlex liner in a Passaic chimney. Most of these are not in the manufacturer brochure:
- Creosote buildup in the corrugations of 316L flexible liners. Wood-burning fireplaces here run long, cold-weather seasons thanks to the Passaic River valley trapping cold air, and third-degree creosote glazes the ridges of a flexible DuraFlex liner faster than you’d expect. The corrugations give creosote a thousand little shelves to hold onto, and once it hardens, a standard wire brush won’t touch it. We use a rotary whip designed for flexible liners to break the glaze without tearing the stainless. If you’re burning wood more than twice a week, you’re a candidate for more frequent cleanings than the once-a-year rule.
- Torn or punctured liner walls from aggressive sweeping. A previous sweep using a steel brush with too much force will score and eventually tear the thin wall of a DuraFlex flexible liner. We see this most often near the top of the flue where brushes catch on the cap connection. A torn liner leaks smoke into the chase and pulls combustion air from the wrong place. Our field vignette from a Passaic wood-burning fireplace earlier this season: homeowner complained of a smoky smell after every fire, and we found glazed creosote plus a torn section near the top where a previous company had gone at it with a steel brush. We removed the creosote with the rotary whip, cut out the torn section, and joined in a new DuraFlex connector with a stainless steel band clamp. The liner drafts cleanly now.
- Corrosion at liner-to-connector joints on older installations. In converted coal-to-gas flues, especially in pre-1930s Passaic row houses, the gas appliance produces acidic condensate that eats at the connector joints on a DuraFlex liner. Moisture plus combustion gases sitting in a cold river-valley flue turns into a mild acid bath at the seams. We check every joint during a Level 2 inspection in this city’s older stock, because that’s where slow leaks start.
- Ovalization or kinking when the liner was pulled through an offset flue. Passaic’s multi-flue brick chimneys often have offsets where the flue jogs around framing or another flue. A DuraFlex liner pulled through an offset without proper support will ovalize or kink, and that restricts draft. You’ll notice it as poor fire performance or smoke rolling back into the room.
- Mismatched liner sizing in multi-family row houses. This is a Passaic-specific pattern. In a two-family rowhouse with a single exterior chimney, it’s common to find one flue properly lined with a 6-inch DuraFlex and the adjacent flue still running bare clay tile from when the building went up. Each flue needs its own documentation because liability and code compliance differ unit-by-unit within the same chimney. We inspect and clean each flue independently and give the owner or landlord a separate report for each one.
DuraFlex Parts & Our Repair-vs-Replace Approach
We use genuine DuraFlex components when replacing connectors, caps, or damaged liner sections. For non-critical parts like top plates or flashing, we source quality aftermarket fittings that match the liner diameter and alloy, because paying the OEM markup on a piece of sheet metal doesn’t make your flue any safer. The stainless alloy matters more than the box it came in.
Our repair versus replace decision is simple. If the stainless steel in your DuraFlex liner is structurally sound, we patch and repair. Small tears under a couple of inches can be joined with a proper connector and stainless band clamps. If corrosion or tearing runs more than a few inches, or the liner has ovalized from a bad pull, replacement is more cost-effective than trying to patch a compromised system. We’ll show you the camera footage so you can see exactly what we’re recommending and why, before you spend a dollar. Call (551) 368-8859 for an honest assessment.
Our DuraFlex Service Process - Step by Step
- 1
Diagnosis. We start with a Level 2 inspection, which means we run a camera through the full length of the DuraFlex liner, documenting every corrugation, joint, and connection point. In Passaic’s older multi-flue homes, we check each flue separately and document each one independently. You get the footage and a plain-English verdict.
- 2
Repair or install. If the liner needs cleaning, we use a rotary whip sized for flexible DuraFlex liners. If there’s a tear or corroded connector, we cut out the damaged section and join in a new DuraFlex connector with stainless steel band clamps. If replacement is the honest call, we’ll tell you that too, and explain why before anyone starts work.
- 3
Test. After any repair or install, we check draft with a smoke test and verify the liner holds with the camera again. We want to see consistent, clean airflow before we finish.
- 4
Warranty & documentation. Every job ends with the 90-Day Done Right Promise in writing. If something isn’t right, one call brings Wendell’s crew back at no additional cost. You’ll also get a record of what was done for your own files, useful if you ever sell the house in Passaic.
DuraFlex Products We Service & Install in Passaic
We clean, inspect, repair, and install the full DuraFlex product range you’re likely to find in a Passaic chimney. That covers the DuraFlex 316L Flexible Chimney Liner, the workhorse for wood-burning fireplaces; the AL 29-4C Flexible Liner, which we see in gas and oil conversions across Passaic’s older housing stock; the ProTech Rigid Liner for taller or more demanding flues; and the Smooth Wall Flexible Liner, which handles creosote better than corrugated stainless because there’s less surface for it to hold onto. We stock common DuraFlex connectors, clamps, and caps for fast local turnaround, and we can order specialized parts when a job calls for them.
If your Passaic home has a DuraFlex liner and you’re not sure which model it is, we’ll identify it during the inspection. Ask anyone on your street.
We Also Service These Brands
DuraFlex isn’t the only name in our trucks. We work with HeatShield resurfacing systems and Gelco liners, plus Olympia Chimney, Famco, and Copperfield products. We keep our brand knowledge broad because Passaic’s chimneys don’t all have the same parts, and neither should your sweep.
FAQs - DuraFlex Chimney Cleaning Service in Passaic
No, a standard wire brush is the wrong tool for a DuraFlex flexible liner and we see damage from that mistake all over Passaic. The thin stainless walls and the corrugations mean a stiff steel brush can score, catch, and tear the liner. We use a rotary whip designed specifically for flexible liners, which cleans the creosote out of the corrugations without stressing the metal.
You’ll usually notice it as a smoky smell after fires or smoke backing up into the room when the fire burns low. A torn liner leaks smoke into the chimney chase instead of sending it outside. The only way to confirm a puncture or tear is a camera inspection. We run a camera through your Passaic chimney’s DuraFlex liner and you’ll see the damage yourself before we quote any repair. Call (551) 368-8859 to schedule one.
DuraFlex liners don’t demand a proprietary cap, but the cap needs to match the liner’s diameter and the flue configuration of your Passaic chimney. An undersized or poorly fitted cap restricts draft and lets water in. We stock caps sized for common DuraFlex liner diameters and we’ll fit the right one during any service or installation. No guesswork and no universal-fit parts that don’t really fit.
Yes, in most cases a small tear under a couple of inches can be cut out and joined with a genuine DuraFlex connector and stainless steel band clamps. We repaired exactly that on a Passaic wood-burning fireplace earlier this season: a torn section near the top from a previous steel-brush sweep. The liner drafts cleanly now and the repair cost far less than a full replacement. If the tear runs longer or the steel is corroded beyond a few inches, replacement is the more cost-effective route. We’ll show you the footage and let you decide.
DuraFlex liners fit most wood-burning fireplaces and stoves, but the flue size has to match what your appliance actually needs. Passaic’s older rowhouses often have oversized coal-era flues, and a liner that’s too big for a modern wood stove will not draft properly. The right size depends on the appliance’s BTU output and the flue’s dimensions. We’ll measure and verify during the inspection, not guess.
Chimney Cleaning & Sweep for DuraFlex in Passaic typically runs between $180 and $340 depending on the liner’s condition, the number of stories, and whether the inspection includes separate documentation for multiple flues in a multi-family rowhouse. The price you hear on the phone is the number on the invoice. Call (551) 368-8859 for an exact quote. Estimates are free, and we’ll tell you honestly if the liner doesn’t need cleaning this year.
Book Your DuraFlex Service in Passaic, NJ
If your DuraFlex liner is overdue for cleaning or something doesn’t feel right with your fireplace, call Top Hat Chimney at (551) 368-8859. Wendell Pike or one of his crew will answer, give you a straight price, and set a real arrival window. Free estimates, no pressure, and the 90-Day Done Right Promise in writing on every job.
Written by Wendell Pike, Owner at Top Hat Chimney, serving Passaic since 1999.





Before
After
Before
After
Before
After